Electrical Installation – operating the Electric in to the Cabinet Print

This guide that is instructional assist in the planning/installation associated with Electrical Power provide for our Acrylic Spas.

Every one of our acrylic tubs have detachable case panels which cover the whole border associated with the tub.

Whenever operating the electric through the spa, the access point in to the case doesn’t need become put appropriate during the Control Pack location. Our spas usually do not come loaded with a pre-drilled gap for electric so access could be through some of the cabinet panels.*

*NOTE: We usually do not advise setting up the electric via a case panel that is situated in front a Pump, Control Pack, Blower, or Gate Valve. These panels will likely must be removed sooner or later for maintenance or servicing.

Selecting a spot

When selecting the best place to go into the cabinet, do this in line with the after:

• safety (don’t create hazards that are tripping
• looks
• access points for users to go into the bath tub
• action positioning
• cover opening position (bottom mount lifters may have the cover remainder low next to the case)
• address lifter mounts

Producing an Access Point

A Spade Bit is not recommended since there are no pre-drilled holes, access through the panel is done using a Hole Saw for a clean cut. The best location to put a gap when it comes to cord, could be less than six ins up through the base of this case panel, and 3 to 4 ins in through the edge that is outside of case panel. Please be aware that the cabinet panels have lumber framework and insulating foam inserts. Make an effort to avoid https://hookupwebsites.org/naughty-flirt-matches-review/ drilling through the lumber framework as this will weaken the structural offer the timber provides.

We don’t suggest coming through the bottom associated with spa. Should this be probably the most perfect path then we recommend you are taking under consideration that you’ll not be able to slip the bathtub by any means.

This might pose issue if a site specialist is needed to access a region of the bath tub this is certainly against an obstruction such as for instance a wall or deck.

The Control Pack (where in fact the electric would be connected) will undoubtedly be located behind one of several case panels straight below your Topside Control Panel (precise location will differ according to spa model).

There is certainly space that is enough the case to operate the ability cable through the access point out the Control Pack once we usually do not totally fill the cavity with spray foam. The energy cable will need to go into the Control Pack through the remaining hand side.

To find out more about linking the electric to your circuit breaker, please click on our solution “Electrical Installation – Correct Wiring for a 240V Supply“.

In the event that you need any further help, please contact client provider.